Photogrammetric evaluation of geometrical tolerance standards: a Darpa Suboff model case study

Authors

  • Fillipe R. Esteves Universidade de São Paulo
  • Helio C. S. Júnior Centro Tecnológico da Marinha em São Paulo
  • André M. Kogishi Instituto de Pesquisas Tecnológicas
  • Bernardo L. R. Andrade Universidade de São Paulo

DOI:

https://doi.org/10.25043/19098642.184

Keywords:

Photogrammetry, DARPA Suboff, Geometric Tolerance

Abstract

A DARPA Suboff scale model was used for the development of an analysis methodology for geometric deviations of the hull, aiming the quality control of model manufacturing process. The surface three-dimensional coordinates were obtained through a photogrammetric survey and analyzed based on statistical tools.

The results were classified according to the ITTC and DIN ISO geometric tolerance standards, allowing the investigation of the compliance of the model to such criteria and the study of local geometric deviations.

Downloads

Download data is not yet available.

Author Biographies

Fillipe R. Esteves, Universidade de São Paulo

Departamento de Engenharia Naval e Oceânica, Universidade de São Paulo, Brazil.

Helio C. S. Júnior, Centro Tecnológico da Marinha em São Paulo

Laboratório de Hidrodinâmica, Centro Tecnológico da Marinha em São Paulo, Brazil.

André M. Kogishi, Instituto de Pesquisas Tecnológicas

Instituto de Pesquisas Tecnológicas. São Paulo, Brazil.

Bernardo L. R. Andrade, Universidade de São Paulo

Departamento de Engenharia Naval e Oceânica, Universidade de São Paulo, Brazil.

References

ERNARDO LUIS RODRIGUES DE ANDRADE; BRUNO LOUREIRO DE ALMEIDA; FILLIPE ROCHA ESTEVES; PEDRO HENRIQUE BULLA et al. Scale model geometric verification using photogrammetry. In: 27o Congresso Internacional De Transporte Aquaviário, Construção Naval E Offshore, 2018, Rio de Janeiro. Anais eletrônicos... Campinas, GALOÁ, 2018. Available at: Access 29 jan, 2019. https://doi.org/10.17648/sobena-2018-87548

DIN ISO; DIN ISO 2768-1-m General tolerances - Part 1: Tolerances for linear and angular dimensions without individual tolerance indications. 1989.

GOM; Photogrammetry Tritop 6.2 Manual Basic. Germany, 2009.

GROVES, N. C.; HUANG, T. T.; CHANG, M. S.; Geometric Characteristics of DARPA Suboff Models. Bethesda: David Taylor Research Center, 1989.

ITTC; Ship Models Recommended Procedures. 2011

Downloads

Published

2019-07-31

How to Cite

Esteves, F. R., Júnior, H. C. S., Kogishi, A. M., & Andrade, B. L. R. (2019). Photogrammetric evaluation of geometrical tolerance standards: a Darpa Suboff model case study. Ciencia Y tecnología De Buques, 13(25), 9–18. https://doi.org/10.25043/19098642.184

Issue

Section

Scientific and Technological Research Articles
QR Code